This specification prescribes requirements for theclassification of surfacing electrodes for shielded metal arcwelding. Solid bare electrodes and rods for surfacing areclassified in AWS A5.21:2001, Specification for Bare Electrodesand Rods for Surfacing (see Clause A8 in Annex A).
Safety and health issues and concerns are beyond the scope ofthis standard and, therefore, are not fully addressed herein. Somesafety and health information can be found in Clauses A5 and A9 inAnnex A. Safety and health information is available from othersources, including, but not limited to ANSI Z49.1, Safety inWelding, Cutting, and Allied Processes, and applicable federaland state regulations.
This specification makes use of both U.S. Customary Units andthe International System of Units (SI). The measurements are notexact equivalents; therefore, each system must be usedindependently of the other without combining in any way whenreferring to material properties. The specification with thedesignation A5.13 uses the U.S. Customary Units. The specificationA5.13M uses the SI Units. The latter are shown within brackets [ ]or in appropriate columns in tables and figures. Standarddimensions based on either system may be used for sizing of fillermetal or packaging or both under A5.13 or A5.13Mspecifications.
- Edition:
- 5.
- Published:
- 01/01/2010
- ANSI:
- ANSI Approved
- Number of Pages:
- 44
- File Size:
- 1 file , 460 KB
Reviews
There are no reviews yet.