ANSI APPROVAL WITHDRAWN MARCH 2004
INTRODUCTION
Intent
The purpose of this procedure is to measure the forces ortorques that are required to fully couple or uncouple a connectorset.
Description
The connector set components are held in a fixture so that acontrolled coupling force or torque can be applied. The force ortorque is measured during the entire coupling and/or uncouplingcycle. The procedure is applicable to either twist type orpush-pull type coupling mechanisms.
Alternative Procedures
This test procedure is an alternative to the measurementprocedure, titled Engagement and Separation Force of IEC 874-1,Third Edition.
- Edition:
- 91
- Published:
- 07/01/1991
- Number of Pages:
- 12
- File Size:
- 1 file , 210 KB
Reviews
There are no reviews yet.