This standard provides an acceptable practice for the design andselection of components for enclosed gear drives.Fundamental equationsprovide for the proper sizing of shafts, keys, and fasteners based onstated allowable stresses.Other components are discussed in a mannerto provide an awareness of their function or specific requirements.This standard applies to the following types of commercial andindustrial enclosed gear drives, individually or in combination; spur,helical, herringbone, bevel and worn.
Exceptions
The equations in this standard are not applicable when gear drives aresubjected to vibratory conditions where there may be unpredictablefatigue failure.
The procedure for design or selection of the specific gear components isvaried and complex and is beyond the scope of this standard.Designersmust refer to the specific rating or enclosed drive standards for thisaspect of drive design.
ABSTRACT
This standard outlines the basic practices for the design and selectionof components, other than gearing, for use in commercial and industrialenclosed gear drives.
- Edition:
- D97
- Published:
- 01/01/1997
- ANSI:
- ANSI Approved
- Number of Pages:
- 48
Reviews
There are no reviews yet.